Electronics Shredder

Pin
Send
Share
Send

Imagine that you have some kind of device that can disable any electronics at a distance. Agree, it seems like the scenario of some kind of science fiction film. But this is not fiction, but quite a reality. Such a device will be able to make almost anyone with their own hands, from parts that can be freely obtained.

Device description


An electronic shredder is an electromagnetic gun that sends powerful directional electromagnetic pulses of high amplitude that can disable microprocessor technology.

Shredder Principle


The principle of operation remotely resembles the operation of a Tesla transformer and a stun gun. An electronic high-voltage boost converter is powered from the battery. The load of the high-voltage converter is a series circuit of a coil and a spark gap. As soon as the voltage reaches the breakdown level of the arrester, a discharge occurs. This discharge makes it possible to transfer all the energy of a high-voltage pulse to a coil of wire. This coil converts a high voltage pulse into a high amplitude electromagnetic pulse. The cycle is repeated several hundred times per second and depends on the frequency of the converter.

Instrument circuit


In the role of a spark gap, one switch will be used - it will not need to be pressed. And the other for switching.

What is needed for assembly?


- 3.7V batteries - aliexpress
- Case - aliexpress
- High voltage converter - aliexpress
- Switches two pieces - aliexpress
- Super glue.
- Hot glue.







Assembly


We take the case and drill holes for the switches. One from the bottom, the other from the top. Now make the coil. Wrap around the perimeter of the body. We fix the coils with hot glue. Each coil is separated from each other. The coil consists of 5 turns. We collect everything according to the scheme, solder the elements. We insert an insulating gasket between the contacts of the high-voltage switch so that the spark is inside and not outside. We fix all the parts inside the case, close the case cover.




Safety requirements


Be especially careful - very high voltage! Perform all manipulations with the circuit only after disconnecting the power source.
Do not use this electromagnetic shredder near medical equipment, or other equipment on which human life may depend.

The result of the magnetic gun


The gun famously knocks out almost all the chips, of course there are exceptions. If you have unnecessary electronic devices, you can check the work on them. The electronic shredder is very small and fits comfortably in your pocket.
Test on the oscilloscope. Keeping the probes at a distance and not connecting, the oscilloscope just rolls over.

Test


We disable the flashing LED with a built-in controller.


Breaking the microwave.

Video assembly instructions.

Pin
Send
Share
Send

Watch the video: ELECTRONICS SHREDDING LCD MONITOR, LAPTOP, PC MOTHERBOARD, TV REMOTE (November 2024).