Share
Pin
Tweet
Send
Share
Send
For the master class in making badges for witnesses, we take:
- Rep ribbons 12 mm wide white and light purple;
- A pattern of seven finite stars with a diameter of 10, 10.5 and 11 cm (patterns are found on the Internet);
- Felled openwork circles from mother-of-pearl cardboard in purple and white;
- Circles with the inscriptions "Honorary Witness" and "Honorary Witness", the diameter of the circles is 5-5.5 cm;
- Pillow burgundy for tinting;
- Two metal pins on a round substrate;
- A piece of white felt;
- White small beads;
- Glue "Focus";
- Scissors;
- Lighter;
- Glue stick or double-sided tape.
Printed templates and circles with inscriptions and you can cut them.
Medals will be applied in this way. From more from below to least from above.
Circles with inscriptions are tinted with a small pillow in a circle and glued to the cut down circles.
Flashing circles. Now we take ribbons and star patterns.
We start from the center, apply the tape, smear a little glue and wrap the tape around the corner of the star and again to the center. So we wrap the star along all sides.
Each asterisk is made with a different ribbon and a different color. Now we carefully remove our ribbon stars from all three patterns.
It turns out these three stars, we make exactly these three stars again. Do not forget to burn the edges of the tapes with a lighter.
Now we begin to collect medals. We start with the largest star, then the middle and small ones up.
We smear the stars from the ribbons in the center with glue, so we glue them into one star. Glue a circle with the inscription in the center. And on the back of the star we glue a felt circle.
And already on a felt circle we glue metal pins on a round basis.
In a circle of inscriptions we glue half beads and medals are ready.
Here are such stylish badges to the color of the wedding. Thank you for your attention and see you later)))
Share
Pin
Tweet
Send
Share
Send